807041 v1.00 03.21 HydroTap G5 UltraCare User guide
22
3.5.3 Dispense times
DISPENSE TIMES 12:12 PM
Chilled
Boiling
14
SEC
07
SEC
Set the “bottle fill” dispense time for each water type.
Minimum dispense time: 5 seconds.
Maximum dispense time: 15 seconds (default).
3.5.4 Light sensor
Follow the on screen instructions.
Ensure the ambient light in the room is typical for
operating conditions.
The lights on the tap will flash to confirm calibration.
When the room is darkened below the calibrated light
level, the tap lights will turn OFF after 30 seconds. Energy
saving modes may occur. Refer to section 3.7 (page 27).
LIGHT SENSOR 12:12 PM
CALIBRATION
This will calibrate the light sensor which will allow the
system to go to sleep when it is dark.
Before we start, the room should be in a typical
ambient lit environment.
Remove any object away from the tap.
SECTION 3: Command Centre Screen
To Next Page
Loading...
