807041 v1. 00 03.21 HydroT ap G5 UltraCare User guide
8
SECTION 2: Tap operation
2.2 Touch-Free Wave
Controls Touch-free
sensors on the tap top,
back and sides.
Lights
Dispense
sensors
Safety
sensor
(at back)
Light
Clearance requirements
100mm 100mm
100mm
100mm
RED Boiling & safety
sensors activated, water
dispensed.
BLUE Chilled sensor
activated, water dispensed.
WHITE Sparkling sensor
activated, water dispensed.
PURPLE Lock mode on (when tap is idle).
Flashing RED Sensor activated incorrectly; hand
may be too close to sensor, sensor has been
touched or covered.
WHITE / BLUE / RED Cycling 5 to 10 seconds
Filter needs replacing, CO warning (G5), unit
is in an error mode (refer to Command Centre
screen).
WHITE Flashing rapidly Sensors calibrating when
power is first applied to the tap. Allow 10 seconds.
To Next Page
Loading...
