6
INSTALLATION INSTRUCTIONS & USER MANUAL
210006 V2.00 SEPT 2017 - ZIP VPII/103-153(UB)
TECHNICAL SUPPORT TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
• This appliance must not be used by any person (inclu ding children) with limited physical,
sensorial or mental abilities or failing experience and/or knowledge unless they are
supervised by a person responsible for their safety or have received instructions about
how to use the appliance.
• The appliance must not be subjected to pressure exceeding 0.55 MPa (5.5 bar). For
supply pressures exceeding 0.35MPa (3.5 bar) it is recommended that a pressure
reducing valve be installed.
• If water discharges from any safety valve switch off the electrical supply to the unit,
isolate the water supply and contact a competent person familiar with unvented systems.
• Do not block or restrict the discharge from any safety valve.
• Do not tamper with any safety valve.
SAFETY INFORMATION
CAUTIONS
• The appliance must only be used when correctly installed and in perfect working order.
• The appliance must be installed in a frost-free room and must never be exposed to frost.
• The Zip Varipoint II range is not recommended for use with secondary circulation systems.
• The appliance must be completely filled with water before being switched on.
• The appliance must only be used for heating wholesome water. The appliance must not be
used for any other purpose.
• When the appliance has been in use for some time, the fittings may be very hot.
• The Zip Varipoint II is intended for connection to mains supply only. In any other case please
contact Zip on 0345 6 005 005 for advice.
• Zip Water UK cannot be held liable for any damages caused by failure to observe
these instructions.
• It is recommended that an HE45004 Water Block is fitted in the water supply line to
minimise the potential damage in the event of any leakage.
To Next Page
Loading...
Need help?
General
