34
RECOVERY
Hold your hands on the heart rate sensors on the handlebar after training and press RECOVERY.
The display counts down from 00:60 to 00:00 and displays a result of F1, F2,… F6.
F1 is the best, F6, the poorest.
Press RECOVERY again to return to the home screen.
BODY FAT
In the STOP mode, put your palm on the heart rate sensor. Press the BODY FAT button to start a fat
tissue measurement.
Enter your data by setting the values with the UP/DOWN buttons and confirming with
MODE:
o Select the sex
o Set the height
o Set the weight
When the data has been entered, put your other hand on the heart rate sensor. The
measurement starts.
Keep your hands on the heart rate sensors during the measurement.
When the computer detects a heart rate, an image is displayed for 8 seconds until the end
of the measurement.
The display shows a series of values: BMI, FAT.
Possible errors:
Message ‘----’, ‘----’ – grip not used correctly.
E-1 – no heart rate input signal detected.
E-4 – FAT% and BMI below 5 or over 50.
PULSE RATE
Put both your hands on the heart rate sensors on the handlebar. During the measurement,
the computer displays a heart icon.
The computer displays the current heart rate after three to four seconds.
ATTENTION! The results are approximated and must not be used for any medical purposes.
MOBILE APP BLUETOOTH PAIRING
The computer is compatible with iConsole+ Training.
Start your training and enjoy new possibilities:
Download the app.
Enable Bluetooth on your mobile device.
Start the app and select the ZIPRO device you want to pair.
When ZIPRO is connected with the app, the computer is turned off and the screen goes
blank. From now on, you control ZIPRO through your mobile device.
To Next Page
Loading...
