Table of Contents
M7IRDA2003I
7IRD-A/J/M: Distribution Protection & Control Terminal
© ZIV APLICACIONES Y TECNOLOGÍA, S.L.U. 2020
IV
10.5.1 Metering Tests ..................................................................................................... 10-4
10.5.2 Phase and Ground Current Test .......................................................................... 10-4
10.5.3 Open Phase Test ................................................................................................. 10-6
10.5.4 Residual Current Test .......................................................................................... 10-6
10.5.5 Breaker Failure Test ............................................................................................ 10-6
10.5.6 Recloser Test (7IRD-A/J Models) ........................................................................ 10-7
10.5.7 Trip/Close Coil Circuit Supervision Input Test ..................................................... 10-8
10.6 Control Subsystem Receiving Tests .................................................................... 10-8
10.6.1 Test Configuration ................................................................................................ 10-8
10.6.2 Digital Inputs Test ................................................................................................ 10-9
10.6.3 Digital Outputs and LEDs Test ........................................................................... 10-10
10.6.4 Metering Test ..................................................................................................... 10-10
10.7 Communication Test .......................................................................................... 10-11
10.8 Installation .......................................................................................................... 10-12
10.8.1 Location .............................................................................................................. 10-12
10.8.2 Connection ......................................................................................................... 10-12
A. PROCOME 3.0 Communications Protocol ....................................................... A-1
A.1 Settings ................................................................................................................. A-2
A.1.1 Configuration Settings ........................................................................................... A-2
A.1.2 Logic Settings........................................................................................................ A-2
A.2 Description of Operation ....................................................................................... A-3
A.2.1 General Settings ................................................................................................... A-3
A.2.2 Logic ...................................................................................................................... A-3
A.2.3 Event Records....................................................................................................... A-3
A.2.4 Fault Report .......................................................................................................... A-4
A.2.5 Inputs .................................................................................................................... A-4
A.2.6 Communicating with the Unit ................................................................................ A-4
A.3 Alphanumeric Keypad and Display ....................................................................... A-5
A.3.1 Configuration ......................................................................................................... A-5
A.3.2 Settings ................................................................................................................. A-6
A.3.3 Accessing the Information ..................................................................................... A-6
B.
DNP 3.0 Communications Protocol .................................................................. B-1
B.1 Physical Architecture ............................................................................................ B-2
B.2 Settings ................................................................................................................. B-2
B.3 Description of Operation ....................................................................................... B-3
B.3.1 DNP 3.0 Protocol .................................................................................................. B-3
B.3.2 Communications ................................................................................................... B-8
B.3.2.a Communication with the Equipment ..................................................................... B-8
B.4 Alphanumeric Keypad and Display ....................................................................... B-8
B.4.1 Change Settings ................................................................................................... B-8
B.4.2 DNP3.0 Protocol ................................................................................................... B-8
B.4.3 Information Access ............................................................................................... B-9
C.
Schemes and Drawings ...................................................................................... C-1
D.
List of Illustrations and Tables .......................................................................... D-1
D.1 List of Figures ........................................................................................................ D-2
D.2 List of Tables ......................................................................................................... D-4
To Next Page
Loading...