Zodiac EIXPERT - Use; EiXpert user interface; Setting the clock

5
Preparing the pool: Adding salt
Add rened pool salt (sodium chloride) at the rate of 4 kg per 1000 litres.
This proporon is equivalent to 4,000 ppm (parts per million). The salt should be added at various posions
into the shallow end of the pool. The salt will spread and dissolve more quickly as it runs down the slope of the
pool towards the deep end. Run pump to mix dissolved salt throughout pool. When all the salt has dissolved,
set the chlorine output control to maximum for the rst few days monitor your chlorine readings and adjust
as required.
Note: Remove the automac pool cleaner before adding salt or other chemicals.
Note that the chlorinator output depends on salt concentraon, water temperature, and mains power voltage.
The nominal standard values of 4,000ppm salt, 25 degrees Celsius water temperature, and correct mains
voltage, will provide maximum output. If any one or more of these three variables are less than the standard
values, the output may be decreased.
Use
EiXpert user interface
Boost
Low
Back
Select
Boost
Low
Back
Select
- Exit the user menu.
- Deacvate Boost mode or Low mode.
Boost
Low
Back
Select
Boost
Low
Back
Select
- From the home screen: increase or decrease in
chlorine producon.
- In the user menu: value changes when a choice is
proposed (ashing characters).
Boost
Low
Back
Select
- Access to user menu and navigaon in the sengs
(with successive presses)
Boost
Low
Back
Select
- Acvate/deacvate the chlorine producon by a
short press.
- Switch o the device with a long press
- Switch on the device with a short press
Boost
Low
Back
Select
Boost
Low
Back
Select
- Press buons together to acvate Boost
mode manually
Boost
Low
Back
Select
Boost
Low
Back
Select
- Press buons together to acvate "Low"
mode manually
Note: Low mode will stay in operaon unl deacvated
Seng the clock
The EiXpert chlorinator is ed with an internal memory and is ed with baery back up that will
maintain memory for several weeks in the event of a power failure. The me is displayed in a 24 hour
format.
• Switch on the device and wait unl screen start-up sequence is nished.