Zodiac EIXPERT - Troubleshooting; Check Salt Warning; Flow Indicator Issues; Cell and Overheat Errors

8
• Leave the cleaning soluon to dissolve the scale deposit for about 15 minutes. Store your cleaning soluon in
a safe place or dispose of according to your local council regulaons, never pour it into the rainwater drainage
system or into sewers.
• Rinse the electrode using clean water and put back into posion.
• Open the isolaon valves (if applicable) and restart the chlorinator and the ltraon system.
* If you do not use a commercially available cleaning soluon, you can manufacture it yourself by
carefully mixing 1 volume of hydrochloric acid with 9 volumes of water (Warning: always pour the acid
into the water and not the opposite and wear suitable protecve equipment!).
Troubleshoong
EiXpert Text Displayed Possible causes Soluons
CLEANING The self-cleaning cycle is
automac; this message is
not an error code but an
informaon message.
• Wait for about 10 minutes and chlorine
producon will resume automacally at the
previously set level.
“Check
Salt”
warning
displayed
CHECK SALT • Salinity is under 3,000ppm.
• Pool water temperature too
low (< 18 °C, variable).
• Cell scaled up or worn.
• Add salt to the pool to keep the level at
4,000ppm. If you do not know the salt level
or how to test it, consult your pool care
professional.
• Display warning will come on when the
water is too cold. No acon required.
• Clean or replace the cell.
“Flow”
indicator
on
NO FLOW • Stop or failure of the
ltering pump.
• Presence of air or gas in the
cell (not lling with water).
• By-pass valves closed.
• Check lter, pump basket & skimmers and
clean them if necessary. Ensure all valves
are set for normal operaon.
• If using a variable speed pump ensure the
speed seng is high enough for adequate
ow through the cell.
• If sucon cleaner is connected to skimmer
check cleaner for blockages or restricon
of ow
CHECK PUMP • This message is displayed
alternately with "NO FLOW"
if the situaon connues.
• Check the pump connecon
into the power pack is
secure.
• Perform the same checks as above.
Note: that EiXpert has built in pump
protecon. This means that EiXpert will
supply power for 4 mins, if there is no ow
detected it will retry aer 20mins. It will
repeat this again and if sll no ow it will
enter into standby and require restarng.
All schedules will remain in memory.
CHECK CELL • Short-circuit in the cell or
cable disconnected/badly
connected.
• Worn electrode.
• Check the cell connecons.
• Replace the cell.
• Have the control box (electronic board
and transformer) checked by a qualied
technician if necessary.
OVERHEAT • Device internal temperature
over 70 °C.
• Device internal temperature
over 80 °C.
• The device reduces its producon to 50 %.
• Producon stops.
• Producon restarts automacally when the
temperature drops.
X
• The device no longer stores
the me.
• Check the condion of the baery.
• Replace it if necessary (3 V baery, type
"CR2032").
==> If the problem continues contact your pool care professional.