Zodiac EIXPERT - Chlorine production activated; Boost mode; Maintenance; Cleaning the electrode

7
• Use the
Boost
Low
Back
Select
and
Boost
Low
Back
Select
buons to set the Timer 1 start minutes, then press
Boost
Low
Back
Select
to store.
• Use the
Boost
Low
Back
Select
and
Boost
Low
Back
Select
buons to set the Timer 1 start hours, then press
Boost
Low
Back
Select
to store.
• Repeat the steps for Timer 2.
• Press the
Boost
Low
Back
Select
buon to store the mers and move to seng the chlorine producon rate.
• Use the
Boost
Low
Back
Select
and
Boost
Low
Back
Select
buons to choose the required chlorine producon rate (from 10 % to 100 %).
Chlorine producon acvated
When chlorine producon starts, the “Start...” message is displayed on screen for about 6 seconds.
“CHLORINATION” is then displayed, indicang that the device is producing chlorine.
“Boost” mode: chlorine producon increased to 100 % for 24 h
In certain cases the pool may need higher than normal chlorinaon (stormy weather, high number of bathers,
etc.). “Boost” mode is used to increase chlorine level quickly.
• Press buons
Boost
Low
Back
Select
and
Boost
Low
Back
Select
simultaneously: “BOOST” is displayed on the screen and 100 % chlorine producon
starts.
• To stop “Boost” mode, press
Boost
Low
Back
Select
.
When "Boost" mode is acvated, the rated chlorine producon sengs are temporarily overridden and
the EiXpert chlorinator will operate for a total of 24 hours at 100 % chlorine producon.
“Low” mode: chlorine producon reduced to 10 % if the pool is covered
If the pool has a covering system (shelter, pool blanket, cover, etc.), “Low” mode is designed to adapt the
chlorine producon to situaons where the pool is covered. Its eect is to limit chlorine producon to 10%.
Manual acvaon:
• Press buons
Boost
Low
Back
Select
and
Boost
Low
Back
Select
simultaneously: “LOW” is displayed on the screen and chlorine producon is
reduced to 10 %.
• To stop “Low” mode, press
Boost
Low
Back
Select
.
Maintenance
Cleaning the electrode
Although the EiXpert is equipped with reverse polarity technology it is sll necessary to check the cell
and if required clean o any build up that may occasionally occur.
• Turn o the chlorinator and the ltraon system, close the isolaon valves (if applicable), and disconnect the
cell power cable.
• Remove the cell and use a cell cleaning soluon* cover all the electrode cell plates.