EasyManuals Logo

ZOLL R Series In-Service Guide

ZOLL R Series
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Connecting and Disconnecting
Locking lever holds pads and cable in place. Press on the
far end of the lever to release.
Placement
Do good skin prep! Remove sweat, lotions, excess
hair.
Posterior Pad (RED)
o Goes on first
o Placed sub scapular to the left
Anterior Pad (BLUE)
o CPR sensor Mid Sternal/Mid Nipple center of the
sternum (where you do compressions)
o Pad should be off-right of the sensor.
Press and Roll” the pad into place
Cables/Caps
1.
Electrotherapy Cable (Is bolted down)
2.
SpO2 (Blue/If Applicable)
3.
3 Lead EKG and/or the cap in place for pacing
4.
EtCO2 (Yellow)
5.
NIBP- Non-Invasive Blood Pressure (Black)
6.
Cable Compartment for all cables attached
One-Step Cable: Comes out the side and is 8 feet in length.
ONESTEP PAD
Alternate Placement (If A/P is not applicable)
Posterior Pad (RED)
o Placed on upper right chest
Anterior Pad (BLUE)
o Placed on left anterior-lateral, remove CPR sensor and place
in center of chest for compressions.
Add 3-lead
Pediatric Pads
Smaller and more suitable.
Any defibrillation that is done will be adjusted by the device. (50J, 70J, 85J)
Integrated 3-Lead ECG
OneStep Adult pads have a built in 3-lead for pacing patients without an extra 3 lead cable.
If attempting to pace with alternate OneStep pad placement (A/A), it is recommended to
attach a separate 3-Lead. Inverting the pad will invert the ECG.

Other manuals for ZOLL R Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZOLL R Series and is the answer not in the manual?

ZOLL R Series Specifications

General IconGeneral
Defibrillator TypeManual and AED
PacingYes
ECG MonitoringYes
SpO2 MonitoringYes
FAST-SpO2Yes
IP RatingIP55
Defibrillator WaveformBiphasic
Energy Levels1-360 Joules
DisplayLCD
Pacer TypeDemand
Pacer Rate30-180 ppm
Pacer Output0 – 140 mA
EtCO2 MonitoringOptional
NIBP MonitoringOptional
Temperature MonitoringOptional
PrinterIntegrated
Battery TypeLithium-ion
CPR FeedbackYes
Data StorageInternal memory
ConnectivityUSB

Related product manuals