ZOLL R Series In-Service Guide

MONITOR MODE (Grey Zone)
LEAD - Change pressing lead. Circulates through Lead I-III and PADS
SIZE - Change to make the waveform tracing bigger or smaller
ALARM SUSPEND
 Default alarm volume is Off
• Alarms On – Press Alarm Suspend button to turn the alarms on
 Temporary Silence - Press again and it will be temporarily disabled the alarms (15 sec for lethal
and 90 sec for non-lethal rhythms)
 Alarms Off - Press and hold for 3-4 seconds and the alarms will be SILENCED until otherwise
activated by the user. (an x will appear next to alarm icons)
 If the patient is in VFib, Vtac, or Asystole, the alarms will automatically sound after 5 seconds.
RECORDER - Starts or stops the paper recorder at any time
SOFT KEYS
NIBP (the button with the picture of an arm, bottom left)
 Press once for one (1) NIBP reading. Press again to abort reading.
 Press and hold for 2 Seconds for STAT mode (as many NIBP measurements as
possible in 5 minutes)
Options
 QRS Vol On - Turns tone on or off
 Low Bright - Adjust Screen Brightness
• Traces - Waveforms you can bring up. (Options——Traces——Trace 2,3)
• More - Reveals “Clock Set” to change time on display
Param
 EtCO2 Setup (ONLY DONE ONCE when a new sensor is connected to this R Series)
1. Insert EtCO2 Single Patient Airway Adapter
2. Press the “Param” Key
3. Press the “EtCO2” Key.
4. Press the “Zero” key. This will take about 10 seconds and will
display “Zeroed” when done.
 NIBP Setup
1. Press the “Param” Key
2. Press the “Setting” Key
3. Press Auto Interval
4. Set time for Auto Interval (default 5 minutes)
Code Marker
 Varies with where the dial is positioned (Defib, Pacer, Monitor)
 Allows you to time stamp different clinical actions and retrieve later on
Report Data (Printing and Data Transfer)
 PRINT
o Print Chart: ECG strips for a specific time or all activated events
o Print Range: Select and print specific event
o Print Log: Chronological list of all interventions since the device has been on for the
current code and previous codes that are stored
• TEST LOG – Log of up to the last 1000 tests performed.
• TRANSFER MODE – Print to WiFi
Alarms
 Set highs and lows for different parameters.
 The alarms will be defaulted back once the device is off for 10 Seconds.

ZOLL R Series Specifications

General

Defibrillator Type	Manual and AED
Pacing	Yes
ECG Monitoring	Yes
SpO2 Monitoring	Yes
FAST-SpO2	Yes
IP Rating	IP55
Defibrillator Waveform	Biphasic
Energy Levels	1-360 Joules
Display	LCD
Pacer Type	Demand
Pacer Rate	30-180 ppm
Pacer Output	0 – 140 mA
EtCO2 Monitoring	Optional
NIBP Monitoring	Optional
Temperature Monitoring	Optional
Printer	Integrated
Battery Type	Lithium-ion
CPR Feedback	Yes
Data Storage	Internal memory
Connectivity	USB