3 Select or click on Disconnect or similarly-named button.
Using WPS as an alternative way to set up your Wireless
Network
If all the Wi-Fi compatible wireless devices on your network support WPS, you can
choose to quickly setup your wireless network by pushing the WPS button on your cable
modem/router and on each wireless device connecting to your cable modem/router.
Windows 8 and Windows 7 users should follow the instructions below: Other computers
or devices such as tablets should go to
If you are using a non Windows computer or
other device that supports WPS.
If you are using a Windows 8.1, 8 or 7, computer:
1 On your desktop, open Connect to a Network on that computer by left-clicking the
network icon in the notification area of the Windows taskbar.
2 A list of available networks is displayed.
3 Typically you then click Zoomxxxx_5G to connect to your Cable Modem/Router’s 5
GHz network. If you do not see Zoomxxxx_5G than most likely your wireless
adapter does not support the 5 GHz network, so go ahead and click on Zoomxxxx
where xxxx are the last 4 hexadecimal characters of the cable modem CM MAC
address. Zoomxxxx is the SSID printed on the bottom label of your Cable
Modem/Router. In the unlikely event that you changed the SSID from the default,
select your new SSID.
4 You will see a screen with a text box for the Security key. If WPS configuration is
supported, you may see a message such as You can also connect by pushing the
button on the router. If you see this message, continue at step 5 below.
24
To Next Page
Loading...
