Beacon Interval
A beacon is a packet broadcast by the router to synchronize
the wireless network. The default interval is 100 ms.
DTIM Interval
Interval of the Delivery Traffic Indication Message (DTIM). A
DTIM field is a countdown field informing clients of the next
window for listening to broadcast and multicast messages.
When the router has buffered broadcast or multicast for
associated clients, it sends the next DTIM with a DTIM
Interval value. Its clients hear the beacons and awaken to
receive the broadcast and multicast message. The default
value is 1.
Fragmentation Threshold
This value specifies the maximum size for a packet before
data is fragmented into multiple packets. If you experience
a high packet error rate, you may slightly increase the
fragmentation threshold. Setting the fragmentation
threshold too low may result in poor network performance.
Only minor reduction of the default value is recommended.
In most cases, it should remain at its default value of 2346.
RTS Threshold
Using this setting can regulate your wireless network if you
experience any inconsistent data flow. Make only minor
adjustments to the default value of 2347.
WPS
The WPS page allows you to configure settings for WPS. Most users will have no need
to change these settings.
To access the WPS page:
1 Click the Wireless menu tab.
2 Then click the WPS submenu.
Figure 7 ExampleWPSpageshows an example of the menu and Table 7 describes the
items you can select.
60
To Next Page
Loading...
