Zoom A1X FOUR - Selecting Patch Memories and Banks; Switching Between Patch Memories; Switching Between Banks

Selecting patch memories and banks
Switching patch memories
1.
Press or .
This changes the patch memory.
Function Operation
Switch to lower-numbered patch memory
Press
Switch to higher-numbered patch memory
Press
HINT
• By continuing to press
or , you can continuously switch patch memories.
• By using the PRESELECT function, you can switch to a patch memory at any location while continuing
to use the tone of the currently selected patch memory. (
“Setting the PRESELECT function” on page
33)
•
When using the BANK HOLD function, switching is limited to patch memories in the same bank. (
“Setting the BANK HOLD function” on page 36)
Switching banks
1.
Press – .
This changes the bank. The LED for the selected bank lights.
Function Operation
Switch to patch memory numbers 10 – 19
Press
Switch to patch memory numbers 20 – 29
Press
Switch to patch memory numbers 30 – 39
Press
Switch to patch memory numbers 40 – 49
Press
Switch to patch memory numbers 50 – 59
Press
15