Editing a Patch
ZOOM A2
15
S C
5 5
Terminate the edit mode
To terminate the edit mode and return
to the play mode, set the Module
selector to the "PLAY" position.
Select the effect type
To switch the effect type
of the selected module,
use the BANK [-]/[+] keys.
Change the parameter
value
To change the setting value of effect
parameters, use the parameter knobs
1 – 3.
NOTE
When you select another patch
after editing, the changes you have
made in edit mode will be lost
unless you store the patch first. To
retain the changes, store the patch
as described on page 16.
NOTE
When a module that is set to off is
selected, the display shows "oF".
NOTE
• When you press the BANK [-]/[+]
keys while a module is set to off,
the module is switched on.
• If you press the BANK [-]/[+] keys
for a module that has only one
effect type, nothing happens.
Which parameter is assigned to a knob depends
on which effect module/effect type is selected
(→ p. 27 – 34).
When you turn a parameter knob, the
corresponding LED lights up and the display
briefly shows the current value of the respective
parameter.
A2 returns to play mode (or manual mode).
eA2.fm 15 ページ ２００５年１０月１４日 金曜日 午後５時２９分
To Next Page
Loading...
Need help?
General
