Zoom B3 - Mastering the Looper Function; Looper Activation and Setup; Setting the Loopers Tempo

26
Using the Looper
Using the Looper
• Turn of the middle unit.
• Turn on the left unit.
1
To activate the Looper
2
To set the recording time
• Press for 1 second.
NOTE
• The looper can record 1.5–40 seconds (20 seconds when UNDO is enabled).
• Ifthesetting(numberofquarternotes)wouldnotfallinthisrange,
it will automatically be adjusted.
•
Changing the TIME setting will erase the currently recorded loop.
NOTE
• Thesettingrangeis40-250.
• Changingthetempowillerasethecurrentlyrecordedloop.
•
This tempo setting is used by every effect, rhythms and the looper.
3
To adjust the tempo
• Youcanalsosetthetempousing.
• Ifnoloophasbeen recorded yet, you canalsoset thetempoby
tapping .
HINT
Manual
Use the footswitch to start and stop recording.
Note mark
Set the recording time by setting the tempo and the number of
quarter notes.