6 7
FLANGER This is a jet sound like an A/DA Flanger.
PRE DLY Sets pre-delay time of effect sound. 0 - 50
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 50
RESO Adjusts the intensity of the modulation resonance. -10 - 10
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
VOL Adjusts the volume. 0 - 100
BASS
FLANGER
Modeled after the A/DA Flanger, this effect has an added parameter that allows you to
adjust the volume balance between the original and effected sounds.
PRE DLY Sets pre-delay time of effect sound. 0 - 50
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 50
RESO Adjusts the intensity of the modulation resonance. -10 - 10
LOCUT Sets the cut-off frequency in the low range of the effect sound.
OFF -
800Hz
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
VOL Adjusts the volume. 0 - 100
VINTAGE
FLANGER
This analog flanger sound is similar to an MXR M-117R.
PRE DLY Sets pre-delay time of effect sound. 0 - 50
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 50
RESO Sets effect resonance. -10 - 10
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
BASS
VINTAGE
FLANGER
This analog flanger sound is similar to an MXR M-117R.
A parameter has been added to cut low frequencies from the effect sound.
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 50
RESO Sets effect resonance. -10 - 10
LOCUT Sets the cut-off frequency in the low range of the effect sound.
OFF -
800Hz
BF
FLANGER 2
This models a BOSS BF-2 Flanger.
PRE DLY Sets pre-delay time of effect sound. 0 - 100
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 100
RESO Adjusts the intensity of the modulation resonance. 0 - 100
KICK
FLANGER
This flanger is controlled using the foot switch.
PRE DLY Sets pre-delay time of effect sound. 0 - 100
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 100
RESO Sets the foot switch function. 0 - 100
MIX Sets effect resonance. 0 - 100
RESET-F Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
ON/OFF Adjusts the LFO reset frequency.
LATCH,
UNLATCH
MODULATION
To Next Page
Loading...
