- 21 -
17. Software (short manual)
A detailed manual for using the software is located on installation CD or is available on
software by pushing „F1“ resp. in menu in Help/Show Manual.
Installation
Supported operating systems: Windows 2000, XP, Vista, 7
1. Put the installation CD in the CD drive
2. When the CD does not starts by itself, run the file „ZFG-3000_Setup.exe“, which
is located on CD.
3. Follow the instructions
Read in data
4. Start the program „ZFG 3000“
5. Click in menu „File“ on „Read in...“
6. Select i.e. the Folder „ZFG“ on the SD-card and click on „ZXZ.nrz“
7. All files in folder will be read in and shown in an overview.
8. Select desired datasets to apply into the document and click OK.
Save and open files
To save and open ducument is equaly to the windows-default. Saved files use the file
extension zfg3.
Print
It is possible to print single protocolls, the statistic (in menu File/Print) or all at once
(menu File/Projectprint)
Single protocol Statistic evaluation
To Next Page
Loading...
Need help?
General
