- 8 -
4. Menu
If you press the <Mode> button, you can call up additional device functions. Use the <Ok>
button to confirm the menu command selected.
Quit the menu by pressing the <On/Off> button.
4.1 Measuring
See chapter 2. and 3.
4.2 Read card (display data saved to SD card)
Select the View card menu command in the menu (see 4.).
Select the saved individual measurements with consecutive number using the <+> or
<-> buttons
The display first shows the consecutive number for the measurement you have
selected, the total number of saved measurements, date and time for saved individual
measurements in addition to the mean settlement, s/v and Evd values.
If you press the <Mode> button, the second display shows the associated coordinates
if these were available for this individual measurement. In addition, you can see the
settlement curves and the three individual settlements.
You can use the <Print> button to print out the report afterwards.
4.3 Delete card
Select the Delete card menu command in the menu.
The number of saved individual measurements is displayed in the second line Contain
data. This menu command enables you to delete all individual measurements in one
step.
4.4 Settings
Select the Options menu command in the menu (see 4.). The following settings are
then visible on the display:
o Language (German, English, French, Polish ….)
o LCD contrast bright - dark
o Type (300mm/10kg, 300mm/15kg, CBR can be switched over depending on
order)
o Unit MN/m² or Mpa
o Text input function: on/off
o Preloading: on/off
o GPS: on/off (display, saving and printout with or without GPS data)* and the
prompt <OFF> Save
If you wish to make changes to the settings, you can do this by selecting one of the
points (e.g. Language) using the <Mode> button.
If you want to change the set language (German) to English, you can do this by
pressing the <+> and <-> buttons.
Once all settings have been checked or the necessary changes have been made, press
the <On/Off> button to save and quit the Options menu.
To Next Page
Loading...
