©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
54
Error Message Potential Cause Suggested Solution
#201 Large connector failure No connection / short circuit
between the heatbed and the
motherboard
-Check if the heatbed cable
is properly connected to the
heatbed
-Check if the heated cable is
properly connected to the
motherboard
-Heatbed cable replacement
-Heatbed cable adapter
replacement
#202 Extruder cable failure No connection / short circuit
between the extruder cable and
the extruder
-Check if the extruder cable is
properly connected
-Extruder cable replacement
-Extruder PCB replacement
#203 X/Y endstop failure No signal coming from the X/Y
axis endstop when the extruder
reaches the “home” position
(front left corner of the housing)
-Check if the X/Y axis endstops
are properly connected
-Carry out X/Y axes mainte-
nance
-X/Y axis endstop replacement
#204 Z endstop failure No signal coming the Z-axis
endstop when the platform is
lowered to the very bottom
-Ensure that nothing is blocking
the platform while it is moving
to the very bottom
-Check if the Z-axis endstop is
properly connected
-Z-axis endstop replacement
#205 Processor’s power supply
failure
There is a problem with the
main power supply
-Check if the power supply is
sucient
-Replace the power cable
-Contact your Reseller/Dis-
tributor
#206 Temperature error Too high extruder temperature
or high extruder temperature
changes
-Check if the heater&thermo-
couple are properly installed
and secured in the hotend
-Check if the extruder cable is
properly connected
-Heater&thermocouple
replacement
-Extruder cable replacement
-Extruder PCB replacement
#207 Hotend heating failure Too low extruder temperature -Check if the heater&thermo-
couple are properly installed
and secured in the hotend
-Check if the extruder cable is
properly connected
-Heater&thermocouple
replacement
-Extruder cable replacement
-Extruder PCB replacement
To Next Page
Loading...
