Zte MF25A - Accessing the Internet; Accessing the Internet by Bridge Mode; Accessing the Internet by Cable Broadband

15
• Bridge Mode
You need to connect the WAN to the Lan port via an Ethernet cable
and set the clients to obtain the IP address automatically. Your
clients can obtain the IP address from the WAN DHCP host and
connect to the Internet directly.
Note:
If you want to change the operation mode, you need to set a xed
IP address between 192.168.1.100 and 192.168.1.200 for the
client, and then log in and open the WebGUI conguration page to
change it.
• Cable Broadband Mode
You need to connect the WAN to the LAN port via an Ethernet cable
and select the WAN Connection Mode.
There are three cable broadband modes: PPPoE, Static and DHCP.
u
In PPPoE mode, enter the User Name and Password and then
set the WAN Connection Mode.
Note:
Your service provider gives you the User Name and Password.
Using Your Device