28
Set which protocol will be used for filtering.
Set how to handle the packet if it matches with the rule.
4. Click Save Changes to add the new filtering rule.
Portmapping
To set portmapping rules, follow the steps below:
1. Turn on the Portmapping.
2. Click Add.
3. Enter the related parameters as described in the following table.
Enter a name for the rule.
Enter the LAN IP address.
Set which protocol will be used for filtering.
4. Click Save Changes to add the new portmapping rule.
Customization
■ Select Settings > Advanced Router > Customization to enable or disable UPnP and Out of
Service Notification on this interface.
To Next Page
Loading...
