SSID: Select the wireless network name that you want to connect to.
PIN：Enter the PIN that is generated by wireless access client.
PBC：
1. Select the PBC mode in the client WPS UI;
2. Select PBC mode in the WPS page of the device and submit;
3. Select the WPS icon on the device screen and press the OK Key to active your device’s
WPS.
4. Please press the "next" button on the Client WPS UI. After a few seconds the client can
access the WLAN, and the result will be shown in the Client WPS UI.
Device Settings
Account Management
Select Settings > Device Settings > Account Management, and the administrator settings
information is shown in the following figure:
You can change the administrator’s password. Click Apply to confirm your configuration.
Reset
Select Settings > Device Settings > Reset, click Reset to set all the settings to their factory default values,
and then the device will restart automatically.
To Next Page
Loading...
