24
Change Advanced Settings
View WAN Information
At the top right of 4G Mobile Hotspot configuration page, you can view network information, such
as the active network, connection status, signal strength, etc.
Enable Port Mapping
If your computer hosts a server, you can enable port mapping so that other users can access the
server.
To enable port mapping:
On the 4G Mobile Hotspot configuration page, log in as Administrator.
Select Settings > Firewall.
Select Enable beside Port Mapping Settings. The Port Mapping list will appear.
Incoming traffic is forwarded to specific ports and devices on your network (using their local
IP addresses).
Identify the ports to forward--Enter the port forwarding information (the IP address, the Port
range, the Protocol and the comment), then select Apply.
Caution: Port mapping creates a security risk. When not required, port mapping should be
disabled.
Enable MAC/ IP/Port Filtering
You can enable or disable the MAC/IP/Port Filtering feature as needed to block certain Internet
traffic. If this setting is enabled, you can then choose whether traffic is Accepted or Dropped by
default by selecting the appropriate option from the Default Policy dropdown.
To Next Page
Loading...
