Zte Z6200 - Troubleshooting

27
 To set the OBD2 device’s LAN options:
 On the 4G Mobile Hotspot configuration page, log in as Administrator.
 Select Settings > Router Settings.
 Enter the desired information in the each section.
 If the DHCP Server is enabled, it automatically assigns an IP address to each device on the
network and manages their configuration information.
 Select Apply.
Troubleshooting
Problem
Suggested Solution
Cannot establish
the Wi-Fi
connection
between your
device and client.
• Refresh network list and select the correct SSID.
• Check the IP address to make sure your client can obtain an IP
address automatically in the Internet protocol (TCP/IP)
properties.
• Type the correct network key (Wi-Fi password) when you
connect to your OBD2 device.
The client
connected to the
device cannot
access the
Internet.
• Make sure your micro-SIM card is available.
• Ensure that the roaming status is turned on. Once turned on and
your OBD2 device connected to mobile network, the LED2
indicator turns green. Select Settings > Network Settings >
WAN Connection Mode Settings on the 4G Mobile Hotspot
configuration page to check the box under Automatic.
• Contact your service provider.
Cannot visit the
4G Mobile Hotspot
configuration
page.
• Enter the correct address. The default address is
http://192.168.0.1.
• Only use one network adapter in your PC.
• Do not use any proxy server.