Zte ZXHN H1600 - Configure the FTP

ZXHN H1600 Maintenance Management Guide
Parameter Description
Source Port Source port number of the matching packets.
Destination Port Destination port number of the matching packets.
Source MAC Address MAC address of the source device that sends the
matching packets.
3. Click Apply button to apply the changes.
6.5 Configure the FTP
The section describes how to configure FTP. FTP provides the parameters of FTP con-
figuration features.
Prerequisite
Before configuring FTP application, make sure a USB storage device is connected to
open the ZXHN H1600 device.
Steps
1. On the main page of the ZXHN H1600, select Local Network > FTP to open the
FTP page, see Figure 6-23.
Figure 6-23 FTP
2. Table 6-16 lists the FTP parameters.
Table 6-16 FTP parameters
Parameter Description
Server Click On to enable the FTP server function.
Click Off to disable the FTP server function.
Username/Password It is valid only if the FTP security function is enabled.
3. Click Apply button to apply the changes.
6-20 SJ-20200218145027-006 | 2021-03-04(R1.0)