ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User’s Manual
7-2
7.2 Daily Maintenance
The running conditions of the device can be detected through the following operations:
1. From the Ethernet switch, PING the management port addresses of all the APs
of this switch, to check whether the AP wired ports work normally.
2. For the hot spots adopting the DHCP mode, check whether the legal users can
obtain such parameters as IP address, gateway and DNS.
3. Check whether the exit route between the user and Internet is smooth.
4. With the wireless network card, in the AP signal coverage ranges, observe the
signal strength and link quality of different areas, PING the gateway IP address,
observe packet losses, and check whether Internet access is normal.
5. Make roaming and handover operations in different AP signal coverage ranges,
and observe packet losses when pinging the gateway IP addresses, and check
whether Internet accesses are normal.
7.3 Version Loading and Upgrade
Before delivering the W140A, the file set and graphical file set of the running version
have been loaded into the W140A flash.
The running version file set comprises the following files:
Runbin Running software
Database.dat Database file
Zxipcmd.dat Command script file
Tf010102.hex Wireless network adapter third party firmware file
Th010000.hex Wireless network adapter third party firmware file
There may be two wireless network adapter third party firmware files, but W140A
needs only one of them.
The graphical file set is the graph library of the WEB configuration page.
TFTP online loading is used for version loading. With TFTP online loading, the
running version file and graphical file sets can be loaded.
To Next Page
Loading...
