Zte ZXR10 - Commands to Configure Layer 2 Isolation; Commands to Configure IP Network Parameters

Chapter Error! Style not defined. Error! Style not defined.
5-15
Parameter description:
Name Range Description
{0} 0
Unit number of the wireless interface. W140A has only
one wireless interface with the unchangeable value of 0.
5.4.11 Commands to Configure Layer 2 Isolation
1. intra-security enable
Command mode: Configure mode
Function: Enable or disable Layer 2 Isolation
Command format: wlan (config) #[no] intra-security enable
2. intra-security gateway
Command mode: Configure mode
Function: Configure the IP address or MAC address of the gateway
Command format: wlan (config) # intra-security gateway {ip A.B.C.D | mac
xx-xx-xx-xx-xx-xx}
Parameter description:
Name Range Description
A.B.C.D IP address IP address of the gateway
xx-xx-xx-xx-xx-xx MAC address MAC address of the gateway
5.4.12 Commands to Configure IP network Parameters
1. ip arp
Command mode: Configure mode
Function: Add/delete ARP list entries
Command format: wlan (config) #[no] ip arp A.B.C.D xx-xx-xx-xx-xx-xx
Parameter description:
Name Range Description
A.B.C.D IP address IP address of the host
xx-xx-xx-xx-xx-xx MAC address Hardware address of the host