Zte ZXR10 - Command to Configure MAC Filter in Wireless Interface Configuration

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User’s Manual
5-38
2. wep set-key
Command mode: Wireless interface configuration mode
Function: Set the key of WEP encryption
Command format: wlan (config-int-wlan) #wep set-key key-id key-text
Parameter description:
Name Range Description
key-id key1, key2, key3, key4 Entry number of the key to be set
key-text
5 or 13 characters, or a
combination of 10 or 26
sexadecimal digits
If it is set to 64-bit encryption, the key_text
argument can be 5 case sensitive characters (in
alphanumeric format), e.g. MyKey, or 10
sexadecimal digits (in hexadecimal format), e.g.
11AA22BB33
If it is set to 128-bit encryption, the key_text
argument can be 13 case sensitive characters (in
alphanumeric format), e.g. MyKey12345678, or
26 sexadecimal digits (in hexadecimal format),
e.g. 00112233445566778899AABBCC
3. wep use-key
Command mode: Wireless interface configuration mode
Function: Set the WEP encryption key to be used
Command format: wlan (config-int-wlan) #wep use-key key-id
Parameter description:
Name Range Description
Key-id key1, key2, key3, key4 Entry number of the key to be used
5.6.5 Command to Configure MAC Filter in Wireless Interface Configuration
Command mode: Wireless interface configuration mode
Function: Configure MAC filter for the wireless interface
Command format: wlan (config-int-wlan) #[no] mac-access-group acl-list-number
direction