Zte ZXR10 - Command to Configure Log Print Information

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User’s Manual
5-16
2. ip route
Command mode: Configure mode
Function: Configure the default routing address for the system
Command format: wlan (config) #[no] ip route A.B.C.D
1
A.B.C.D
2
A.B.C.D
3
Parameter description:
Name Range Description
A.B.C.D
1
IP address IP address of the host
A.B.C.D
2
Subnet mask IP address mask of the host
A.B.C.D
3
IP address IP address of the next-hop router
3. ip pool
Command mode: Configure mode
Function: Configure the IP address pool for the system
Command format: wlan (config) #[no] ip pool index A.B.C.D
1
A.B.C.D
2
A.B.C.D
3
Parameter description:
Name Range Description
index 0~9 Group number of the IP address pools
A.B.C.D
1
IP address Starting IP address of the host address pool
A.B.C.D
2
IP address Ending IP address of the host address pool
A.B.C.D
3
Subnet mask Subnet mask of the addresses in an address pool
5.4.13 Command to Configure Log Print Information
1. logmsg all-enable
Command mode: Configure mode
Function: Open or close the log print information in all modules
Command format: wlan (config) #[no] logmsg all-enable
2. logmsg level
Command mode: Configure mode
Function: Configure the level of log print information to be output
Command format: wlan (config) # logmsg level level-num