Zte ZXR10 - Command to Configure MAC Filter for the Ethernet Interface; Wireless Interface Configuration Mode; Command to Configure 80211 B-Related Parameters for the Wireless Interface

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User’s Manual
5-34
5.5.4 Command to Configure MAC filter for the Ethernet Interface
Command mode: Ethernet Interface Configuration Mode
Function: Configure MAC filter for the Ethernet interface
Command format: wlan（config-int-ethernet）#[no] mac-access-group acl-number
direction
Parameter description:
Name Range Description
acl-num 1~99 MAC filter entry number bound to the interface
direction in Bind to the "in" direction of the interface
5.6 Wireless Interface Configuration Mode
Mode of entry: Enter the
interface wlan
command in configure mode
Exit mode: Exit and enter configure mode
Default prompt: wlan (config-int-wlan)#
Note: In this mode (including the sub-mode), all information can be configured for
relevant interfaces.
5.6.1 Command to Configure 80211b-related Parameters for the Wireless
Interface
1. 80211b channel
Command mode: Wireless interface configuration mode
Function: Set the current operating channel
Command format: wlan (config-int-wlan) #80211b channel channel-num
Parameter description:
Name Range Description
channel-num 1~13 Wireless channel number: 6 by default
2. 80211b dynamic-key
Command mode: Wireless interface configuration mode
Function: Set the dynamic key of the wireless network
Command format: wlan (config-int-wlan) #80211b dynamic-key key