Chapter 10 - Voice Typical Configurations
Confidential and Proprietary Information of ZTE CORPORATION 133
Step 2 Configure MGCP Protocol
1. Click the MGCP Basic link on the left part to enter the
MGCP basic configuration page.
2. Select the uplink interface and port in the Host
Information field.
3. Fill in the domain name, IP address and port of the first
CA server, which are provided by the service provider, in
the First CA filed. If the service provider does not provide
the domain name, use the default value.
4. Fill in the Domain Name, IP address and port in the
Second CA field, you can use the default values unless
the service provider has special requirements.
5. Configure the domain name (which is provided by the
service provider) for the end port (End Point).
6. Configure the register mode and the name prefix (which
are provided by the service provider) for the port (End
Point). If the service provider does not provide them, use
the default value.
7. Click Apply to finish the basic MGCP configuration.
To Next Page
Loading...
