Chapter 8 Home Networking
AMG1312-T Series User’s Guide
118
Figure 48 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 31 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your AMG1312-T Series in dotted
decimal notation, for example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your AMG1312-T Series automatically computes the
subnet mask based on the IP Address you enter, so do not change this field unless you
are instructed to do so.
Dynamic Route
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. Select the RIP version from RIP1 and RIP2.
Direction
Use this field to control how much routing information the VDSL Router sends and
receives on the subnet. Select the RIP Direction from None, Both, IN Only and
OUT Only.
Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish
membership in a multicast group. The AMG1312-T Series supports IGMP v1/IGMP
v2/IGMP v3. Select None to disable it.
IGMP Snooping Select Enabled to activate IGMP Snooping. This allows the AMG1312-T Series to
passively learn memberships in multicast groups. Otherwise, select Disabled to
deactivate it.
DHCP Server State
To Next Page
Loading...
