Chapter 8 Home Networking
AMG1312-T Series User’s Guide
125
8.7 The File Sharing Screen
Use this screen to set up file sharing through the AMG1312-T Series. The AMG1312-T Series’s LAN
users can access the shared folder (or share) from the USB device inserted in the AMG1312-T
Series. To access this screen, click Network Setting > Home Networking > File Sharing.
Figure 54 Network Setting > Home Networking > File Sharing
DAD
attempts
Specify the number of DAD (Duplicate Address Detection) attempts before an IPv6
address is assigned to the AMG1312-T Series LAN interface. Possible values for this
field are 1-7.
DHCPv6
DHCPv6
Server
Use this field to Enable or Disable DHCPv6 server on the AMG1312-T Series.
DNSv6
Mode
Select the DNS role (Proxy or Relay) that you want the AMG1312-T Series to act in
the IPv6 LAN network. Alternatively, select Manual and specify the DNS servers’ IPv6
address in the fields below.
Primary
DNS
This field is available if you choose Manual as the DNSv6 mode. Enter the first DNS
server IPv6 address the AMG1312-T Series passes to the DHCP clients.
Secondary
DNS
This field is available if you choose Manual as the DNSv6 mode. Enter the second DNS
server IPv6 address the AMG1312-T Series passes to the DHCP clients.
Informatio
n refresh
time
Enter the number of seconds a DHCPv6 client should wait before refreshing information
retrieved from DHCPv6.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 36 Network Setting > Home Networking > IPv6 LAN Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
