ZyXEL Communications AMG1312-T Series - Setting Up a Secure Wireless Network

Chapter 4 Tutorials
AMG1312-T Series User’s Guide
37
In the Network Setting > Broadband screen’s IPv6 Address configuration section, select
Obtain an IP Address Automatically. In the DHCP IPv6 field select DHCP to obtain an IPv6
address from a DHCPv6 server. In the DHCP PD field select Enable to have the AMG1312-T Series
pass the WAN prefix to LAN hosts. The LAN hosts can then use the prefix to generate their IPv6
addresses.
4.4 Setting Up a Secure Wireless Network
Thomas wants to set up a wireless network so that he can use his notebook to access the Internet.
In this wireless network, the AMG1312-T Series serves as an access point (AP), and the notebook is
the wireless client. The wireless client can access the Internet through the AP.
Thomas has to configure the wireless network settings on the AMG1312-T Series. Then he can set
up a wireless network using WPS (Section 4.4.2 on page 38) or manual configuration (Section 4.4.3
on page 42).
4.4.1 Configuring the Wireless Network Settings
This example uses the following parameters to set up a wireless network. In the client, choose the
AP with the SSID configured here. When prompted for a key, use the Pre-Shared Key configured
here.
IPv6
IPv6
IPv6
SSID SecureWirelessNetwork
Security Mode WPA2-PSK
Pre-Shared Key DoNotStealMyWirelessNetwork
802.11 Mode 802.11b+g+n