Chapter 21 TR-069 Client
AMG1312-T Series User’s Guide
201
Figure 109 Maintenance > TR-069 Client
The following table describes the fields in this screen.
Table 84 Maintenance > TR-069 Client
LINK DESCRIPTION
CWMP Select Enable to allow the AMG1312-T Series to be managed by a management server or
select Disable to not allow the AMG1312-T Series to be managed by a management server.
ACS URL Type the IP address or domain name of the management server. If the AMG1312-T Series is
behind a NAT router that assigns it a private IP address, you will have to configure a NAT
port forwarding rule on the NAT router.
ACS User Name The user name is used to authenticate the AMG1312-T Series when making a connection to
the management server. This user name on the management server and the AMG1312-T
Series must be the same. Type a user name of up to 255 printable characters found on an
English-language keyboard. Spaces and characters such as @#$%^&*()_+ are allowed.
ACS Password The password is used to authenticate the AMG1312-T Series when making a connection to
the management server. This password on the management server and the AMG1312-T
Series must be the same. Type a password of up to 255 printable characters found on an
English-language keyboard.
Connection
Request Path
Type the IP address or domain name of the AMG1312-T Series. The management server
uses this path to verify the AMG1312-T Series.
Connection
Request Port
The default port for access to the AMG1312-T Series from the management server is port
7547. If you change it, make sure it does not conflict with another port on your network and
it is recommended to use a port number above 1024 (not a commonly used port). The
management server should use this port to connect to the AMG1312-T Series. You may
need to alter your NAT port forwarding rules if they were already configured.
Connection
Request
UserName
The user name is used to authenticate the management server when connecting to the
AMG1312-T Series. Type a user name of up to 255 printable characters found on an English-
language keyboard. Spaces and characters such as @#$%^&*()_+ are allowed.
Connection
Request
Password
The password is used to authenticate the management server when connecting to the
AMG1312-T Series. Type a password of up to 255 printable characters found on an English-
language keyboard. Spaces are not allowed.
Inform Select Enable to have the AMG1312-T Series periodically send information to the
management server (recommended if CWMP is enabled) or select Disable to not have the
AMG1312-T Series periodically send information to the management server
Inform Interval The interval is the duration in seconds for which the AMG1312-T Series must attempt to
connect with the management server to send information and check for configuration
updates. Enter a value between 1 and 86400 seconds.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
