Chapter 4 Web Configurator
GS1200 Series User’s Guide
23
2 Forget the password and/or IP address.
3 You forgot to log out of the Switch from a computer before logging in again on another computer.
Note: Be careful not to lock yourself and others out of the Switch.
If you forget the administrator password or cannot access the Web Configurator, you will need to use
the Reset button at the front panel of the
Switch to reset it back to the factory defaults.
This means that you will lose all configurations that you had previously and the password will be reset to
“1234”. IP address will also be reset to 192.168.1.3.
1 Make sure the PWR/SYS LED is on (not blinking).
2 To set the device back to the factory default settings, press the Reset button for 10 seconds or until the
PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to blink, the defaults
have been restored and the device restarts.
4.5 Logging Out of the Web Configurator
Click the logout icon in a screen to exit the Web Configurator. You have to log in with your password
again after you log out. This is recommended after you finish a management session for security reasons.
Note: You are automatically logged out of the Web Configurator after 5 minutes of inactivity.
To Next Page
Loading...
