ZyXEL Communications GS1200 SERIES - Initial Setup Example; Initial Setup Overview; Changing the IP Address

GS1200 Series User’s Guide
24
CHAPTER 5
Initial Setup Example
5.1 Overview
This chapter shows how to set up the Switch for use.
The following lists the configuration steps for the initial setup:
• Change the IP Address
• Change the Password
5.1.1 Change the IP Address
If you do not wish to set your Switch as a DHCP client (DHCP client field is Disable), assign an IP address
for the Switch. The IP address makes it accessible from an outside network. It is used by the Switch to
communicate with other devices in other networks.
In this example, you want to change the IP address to 192.168.1.5.
1 Click Management in the navigation panel to open the following screen.
Figure 18 Change the IP Address
2 Enter the new IP address 192.168.1.5 in the IP Address field.
3 Click Apply.
4 The following screen appears. Click OK to save the setting. Connection to the Web Configurator will be
lost.
Figure 19 Lost Connection Warning