Chapter 6 Tutorials
GS1200 Series User’s Guide
37
4 Reboot the Switch.
6.8 Power over Ethernet (PoE) Configuration
This example is for GS1200-5HP v2 and GS1200-8HP v2.
See Figure 34 on page 46 for an example of using PoE to power devices.
Before connecting devices that require PoE to the PoE ports, PD (Powered Devices), you must enable
PoE on those ports.
1 Click Port in the navigation panel.
2 Go to Port Setting, select Enable or Disable for ports that will supply power to PDs in the PoE field, and
click Apply to save your changes back to the Switch.
3 After connecting the PDs to the PoE ports, you can go to the System screen to check the amount of
power the PDs are consuming (PoE Status), the maximum power the Switch can provide (PoE Total
Power), and so on. See Section 7.2 on page 40 for more information about PoE.
Note: The total power the Switch can supply is 60 W, and it is shown in the PoE Total Power
field. The maximum power a PoE port can supply is 30 W.
To Next Page
Loading...
