ZyXEL Communications GS1920-24v2 - Add;Edit Poe Time Range

Chapter 33 PoE Setup
GS1920v2 Series User’s Guide
206
33.3.1 Add/Edit PoE Time Range
To access this screen, click the Add/Edit button or select an entry from the list and click the Add/Edit
button.
Figure 139 PORT > PoE Setup > PoE Time Range Setup > Add/Edit
The following table describes the labels in this screen.
Add/Edit Click Add/Edit to add a new rule or edit a selected one.
Delete Check the rules that you want to remove and then click the Delete button.
Table 98 PORT > PoE Setup > PoE Time Range Setup (continued)
LABEL DESCRIPTION
Table 99 PORT > PoE Setup > PoE Time Range Setup > Add/Edit
LABEL DESCRIPTION
Port Enter the number of the port to which you want to apply a schedule.
Time Range This field displays the name of the schedule that you have created using the SYSTEM > Time
Range screen.
Select a pre-defined schedule to control when the Switch enables PoE to provide power on
the port. To select more than one schedule, press [SHIFT] and select the choices at the same
time.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.