Chapter 49 VLAN
GS1920v2 Series User’s Guide
300
The following table describes the labels in this screen.
49.4 Configure a Static VLAN
Use this screen to view and configure a static VLAN for the Switch. Click SWITCHING > VLAN > VLAN
Setup > Static VLAN to display the screen as shown next.
Figure 213 SWITCHING > VLAN > VLAN Setup > Static VLAN
The following table describes the related labels in this screen.
Table 158 SWITCHING > VLAN > VLAN Status > VLAN Status Details
LABEL DESCRIPTION
VID This is the VLAN identification number that was configured in the corresponding VLAN
configuration screen.
Elapsed Time This field shows how long it has been since a normal VLAN was registered or a static VLAN was
set up.
Status This field shows how this VLAN was added to the Switch.
• Dynamic: using GVRP
• Static: added as a permanent entry
• Voice: manually added as a Voice VLAN
• MVR: added through multicast VLAN registration
• MAC-based: manually added as MAC-based VLAN
Port Number This section displays the ports that are participating in a VLAN. A tagged port is marked as T, an
untagged port is marked as U and ports not participating in a VLAN are marked as “–“.
Table 159 SWITCHING > VLAN > VLAN Setup > Static VLAN
LABEL DESCRIPTION
VID This field displays the ID number of the VLAN group.
Active This field indicates whether the VLAN settings are enabled or disabled.
Name This field displays the descriptive name for this VLAN group.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new static VLAN or edit a selected one.
Delete Click Delete to remove the selected static VLAN.
To Next Page
Loading...
