Chapter 39 Multicast
GS1920v2 Series User’s Guide
232
The following table describes the fields in the above screen.
39.8 MLD Snooping-proxy VLAN
Click SWITCHING > Multicast > IPv6 Multicast > VLAN screen to display the screen as shown. See Section
39.1 on page 219 for more information on multicasting.
Figure 161 SWITCHING > Multicast > IPv6 Multicast > VLAN: MLD Snooping-proxy VLAN
The following table describes the fields in the above screen.
39.8.1 Add/Edit MLD Snooping-proxy VLAN
The screen allows you to enable and configure MLD Snooping-proxy settings on a VLAN you specified.
Table 112 SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-proxy
Use these settings to configure MLD snooping-proxy.
Active Enable the switch button to enable MLD snooping-proxy on the Switch to minimize MLD
control messages and allow better network performance.
802.1p Priority Select a priority level (0 – 7) to which the Switch changes the priority in outgoing MLD
messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 113 SWITCHING > Multicast > IPv6 Multicast > VLAN: MLD Snooping-proxy VLAN
LABEL DESCRIPTION
MLD Snooping-proxy VLAN
Index This is the index number of the MLD snooping-proxy VLAN entry in the table.
VID This field displays the ID number of the VLAN group.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entry.
To Next Page
Loading...
