Chapter 13 Spanning Tree Protocol
MES-3528 User’s Guide
128
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes
on the Switch. Click Configuration in the Advanced Application > Spanning
Tree Protocol.
Figure 70 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 26 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or
Multiple Spanning Tree. See Section 13.1 on page 121 for
background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
