Chapter 23 VLAN Stacking
MES-3528 User’s Guide
189
23.4 Configuring VLAN Stacking
Click Advanced Application > VLAN Stacking to display the screen as shown.
Figure 97 Advanced Application > VLAN Stacking
The following table describes the labels in this screen.
Table 54 Advanced Application > VLAN Stacking
LABEL DESCRIPTION
Active Select this checkbox to enable VLAN stacking on the Switch.
SP TPID TPID (Tag Protocol Identifier) is a standard Ethernet type code identifying the
frame and indicates whether the frame carries IEEE 802.1Q tag information. SP
TPID (Service Provider Tag Protocol Identifier) is the service provider VLAN
stacking tag type.
Choose 0x8100 or 0x9100 from the drop-down list box or select Others and
then enter a four-digit hexadecimal number from 0x0000 to 0xFFFF. 0x denotes
a hexadecimal number. It does not have to be typed in the Others text field.
Port The port number identifies the port you are configuring.
To Next Page
Loading...
