P-2602H(W)(L)-DxA Series User’s Guide
Chapter 4 VoIP Wizard And Example 71
CHAPTER 4
VoIP Wizard And Example
This chapter shows you how to configure your SIP account(s) and make a VoIP phone call.
4.1 Introduction
The ZyXEL Device has Voice over IP (VoIP) communication capabilities that allow you to
use a traditional analog telephone to make Internet calls. You can configure the ZyXEL
Device to use up to two SIP based VoIP accounts.
This section describes how you can set up your ZyXEL Device to call someone who is also
using a VoIP device. Make sure your telephone is connected to the Phone 1 port before you
start with our example.
In the following figure, A represents your phone and B represents the phone of the person you
would like to call.
Figure 30 VoIP Phone Calls
In order to make VoIP calls you need to register at least one SIP account on your ZyXEL
Device. You can register your SIP account in the VOICE OVER INTERNET SETUP
wizard.
4.2 VoIP Wizard Setup
1 After you enter the password to access the web configurator, select Go to Wizard setup
and click Apply. Otherwise, click the wizard icon ( ) in the top right corner of the web
configurator to display the wizard main screen.
To Next Page
Loading...
