Chapter 5 Web Interface Tutorials
NR/FWA Indoor Series User’s Guide
48
1 Make sure you have the Ethernet WAN port connect to a modem or router.
2 Go to Network Setting > Broadband and then the following screen appears. Click Add New WAN
Interface to add a WAN connection.
3 To set the Zyxel Device to Routing mode, see Section 1 on page 48.
To set the Zyxel Device to Bridge mode, see Section 1 on page 49.
Routing Mode
1 In this routing mode example, configure the following information for the Ethernet WAN connection.
2 Enter the General settings provided by your Internet service provider.
•Enter a Name to identify your WAN connection.
• Set the Type to Ethernet.
• Set your Ethernet connection Mode to Routing.
• Choose the Encapsulation specified by your Internet service provider. For this example, select IPoE as
the WAN encapsulation type.
• Set the IPv4/IPv6 Mode to IPv4 Only.
3 Under Routing Feature, enable NAT and Apply as Default Gateway.
4 For the rest of the fields, use the default settings.
5 Click Apply to save your settings.
General
Name My ETH Connection
Type Ethernet
Connection Mode Routing
Encapsulation (Internet
Type)
IPoE
IPv6/IPv4 Mode IPv4 Only
To Next Page
Loading...
