Chapter 6 Wireless LAN
NWA1121-NI User’s Guide
77
6.6.2 Security: 802.1x Only
This screen varies depending on the operating mode you select in the Wireless LAN > Wireless
Settings screen.
6.6.2.1 Access Point
Use this screen to use 802.1x-Only security mode for your NWA1121-NI that is in root AP, MBSSID
or repeater operating mode. Select 802.1x-Only in the Security Mode field to display the
following screen.
Figure 29 Security: 802.1x Only for Access Point
The following table describes the labels in this screen.
Key 1 to
Key 4
The WEP keys are used to encrypt data. Both the NWA1121-NI and the wireless stations
must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You can configure up to four keys, but only one key can be activated at any one time.
Back Click Back to return to the previous screen.
Apply Click Apply to save your changes.
Cancel Click Cancel to begin configuring this screen afresh.
Table 16 Security: WEP (continued)
LABEL DESCRIPTION
Table 17 Security: 802.1x Only for Access Point
LABEL DESCRIPTION
Security Settings
Profile Name This is the name that identifying this profile.
Security Mode Choose 802.1x-Only in this field.
Rekey Options
To Next Page
Loading...
