Chapter 9 Network
NWA/WAC/WAX Series User’s Guide
112
PVID This field displays the PVID of a port.
You can click Edit to set the PVID in the Edit Port screen.
This only governs the incoming untagged packets. The Zyxel Device will tag packets
received on the port with the specified PVID. The packets will then be sent to the VLANs
they belong to accordingly.
VLAN Configuration
Add Click this to create a new entry. For features where the entry’s position in the numbered list is
important (features where the Zyxel Device applies the table’s entries in order like the SSID
for example), you can select an entry and click Add to create a new entry after the
selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings. In some tables you can just click a table entry and edit it directly in the
table. For those types of tables small red triangles display for table entries with changes that
you have not yet applied.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
Activate/
Inactivate
To turn on an entry, select it and click Activate. To turn off an entry, select it and click
Inactivate.
# This is the index number of the VLAN ID.
Status This field indicates whether the VLAN is enabled (a yellow bulb) or not (a gray bulb).
Name This field displays the name of each VLAN.
VID This field displays the VLAN ID.
Note: The VLAN ID you set here will be added as an entry in the Wireless Bridge
VLAN Settings table.
Member This field displays the VLAN membership to which the port belongs.
This also displays if outgoing packets from the port are tagged or not. (T) means the packets
going out from the port are tagged. (U) means the packets going out from the port are
untagged.
Note: For WAX620D-6E, WAX640S-6E, and NWA220AX-6E, the Tx-tagging settings
are unconfigurable. The Tx-tagging settings will be synced with the PVID
settings in the Port Settings table. If the VID is the same as the PVID set on
the port, the outgoing traffic will be untagged, the member port will display
(U). Otherwise, the outgoing packets will be tagged with the VID, the
member port will display (T).
Wireless Bridge Vlan Setting
This section appears if your Zyxel Device supports wireless bridge. See the feature comparison table in Section 1.2
on page 14.
Add Click this to add an entry in the table.
Remove Select an entry and click this to remove the selected entry.
# This field is a sequential value. It is not associated with any VLAN ID.
Wireless Bridge
Vlan ID (1-4094)
Enter a VLAN ID for the wireless bridge. Duplicate VLAN IDs are not allowed.
The VLAN IDs you set on your root AP should be the same as the VLAN IDs you set here. See
Section 1.3 on page 22 for more information on wireless bridge.
Note: The VLAN ID you set here will be added as an entry in the VLAN
Configuration table.
Table 40 Configuration > Network > VLAN (continued)
LABEL DESCRIPTION
To Next Page
Loading...
