ZyXEL Communications nwa series - 9.6 NCC Discovery

Chapter 9 Network
NWA/WAC/WAX Series User’s Guide
115
9.6 NCC Discovery
You can manage the Zyxel Device through the Zyxel Nebula Control Center (NCC). Use this screen to
configure the proxy server settings if the Zyxel Device is behind a proxy server.
To access this screen, click Configuration > Network > NCC Discovery.
Figure 71 Configuration > Network > NCC Discovery
Each field is described in the following table.
Table 43 Configuration > Network > NCC Discovery
LABEL DESCRIPTION
Nebula Control Center Status
Internet This field displays whether the Zyxel Device can connect to the Internet.
Nebula Connectivity This field displays whether the Zyxel Device can connect to the Zyxel Nebula Control
Center (NCC).
Nebula Control Center Discovery Setting
Enable Select this option to turn on NCC discovery on the Zyxel Device. The Zyxel Device will try
to discover the NCC and go into NCC management mode when it is connected to the
Internet and has been registered in the NCC.
If NCC discovery is disabled, the Zyxel Device will not discover the NCC and remain in
standalone operation.
Use Proxy to Access NCC If the Zyxel Device is behind a proxy server, you need to select this option and configure
the proxy server settings so that the Zyxel Device can access the NCC through the
proxy server.
Proxy Server Enter the IP address of the proxy server.
Proxy Port Enter the service port number used by the proxy server.
Authentication Select this option if the proxy server requires authentication before it grants access to
the NCC.
User Name Enter your proxy user name.
Password Enter your proxy password.