Chapter 2 AP Management
NWA/WAC/WAX Series User’s Guide
32
Figure 8 Traffic Monitoring Graph From NCC
See the NCC (Nebula Control Center) User’s Guide for how to configure Nebula managed devices. See
Chapter 26 on page 257 if you want to change the Zyxel Device’s VLAN setting or manually set its IP
address.
Note: Make sure your network firewall allows TCP ports 443, 4335, and 6667 as well as UDP port
123 so the device can connect to and sync with the NCC.
2.1.3 AP Controller (AC)
If the Zyxel Device supports management using an AC (see Section 9.1.1 on page 104) such as the
ZyWALL ATP, ZyWALL VPN, USG FLEX, and the NXC series, and you have this AC in the same subnet, it will
be managed by the controller automatically. To set the Zyxel Device to be managed by an AC in a
different subnet or change between management modes, use the AC Discovery screen (see Section
9.5 on page 113 and Section 9.1.1 on page 104). You can use the AC to manage multiple Zyxel Devices.
See Section 9.1.1 on page 104 for an example AC managed network topology.
To Next Page
Loading...
