Chapter 10 Wireless
NWA/WAC/WAX Series User’s Guide
121
Figure 75 Configuration > Wireless > AP Management > Setup Wireless Bridge Vlan ID: Wireless Bridge
Vlan Setting (for Zyxel Device with multiple Ethernet ports)
Each field is described in the following table.
Table 44 Configuration > Wireless > AP Management
LABEL DESCRIPTION
Radio 1 Setting
Radio 1 Activate Select the check box to enable the Zyxel Device’s first (default) radio.
Radio 1 OP Mode Select the operating mode for radio 1.
AP Mode means the radio can receive connections from WiFi clients and pass their data
traffic through to the Zyxel Device to be managed (or subsequently passed on to an
upstream gateway for managing).
MON Mode means the radio monitors the broadcast area for other APs, then passes their
information on to the Zyxel Device where it can be determined if those APs are friendly or
rogue. If a radio is set to this mode it cannot receive connections from WiFi clients (see
Section 1.3.3 on page 26).
Root AP means the radio acts as an AP and also supports the wireless connections with
other APs (in repeater mode) to form a WDS (Wireless Distribution System) to extend its
wireless network.
Repeater means the radio can establish a wireless connection with other APs (in either root
AP or repeater mode) to form a WDS.
Radio 1 Profile Select the radio profile the radio uses.
Note: You can only apply a 2.4G AP radio profile to radio 1. Otherwise, the first
radio will not be working.
Radio 1 WDS Profile This field is available only when the radio is in Root AP or Repeater mode.
Select the WDS profile the radio uses to connect to a root AP or repeater.
To Next Page
Loading...
